Manufacturing Technical Solutions for High-Volume Production Problems

GLOBAL's manufacturing technical solutions combine engineered automation with the technical resources to run it—robotic cells, controls engineering, machine vision, line retrofits, simulation, commissioning, and FANUC service. The right mix is built around the customer's parts, cycle-time targets, quality requirements, facility constraints, and existing equipment. Where a project needs a complete system, GLOBAL delivers it turnkey; where it needs targeted engineering, GLOBAL scopes and delivers that work, and often both. Documentation and training accompany every delivered system.

GLOBAL supports automotive and EV manufacturers, Tier 1 suppliers, aerospace, heavy equipment, agriculture, appliance, consumer products, and general industrial producers across North America and beyond. Because the work starts from the application rather than a fixed template, methods proven in one industry can be adapted where the technical challenge is similar. Typical work spans machine tending, welding, assembly, dispensing, material handling, and inspection.

A technical solution follows a defined path: process and feasibility analysis, concept development, then mechanical, controls, and tooling design supported by offline simulation. GLOBAL builds and integrates the system, validates it during factory acceptance testing, and then installs, commissions, and runs it off on the plant floor. When a project calls for added engineering capacity instead of a full system, GLOBAL can carry that work as a defined engineering services scope.

Yes. Solutions are engineered to fit the customer's standards and work across common robot, PLC, and HMI platforms so existing maintenance skills and spares still apply. As a FANUC-focused integrator, GLOBAL often centers robotic work on FANUC while specifying controls and components to match the plant. Matching existing platforms early keeps both commissioning and long-term support straightforward.

GLOBAL modernizes existing equipment through robot retrofits, new controls or vision, cell optimization, and manual-to-automated conversion, and also delivers complete new systems. Current equipment is assessed for condition, interfaces, and cycle capability so useful assets are kept where they still perform. A full replacement is recommended only when modernizing would cost more than it returns, and the trade-off is laid out before any commitment.

GLOBAL provides FANUC programming, troubleshooting, maintenance, training, controls and commissioning support, with after-hours support for nights, weekends and planned shutdowns. That means support does not end at installation—manufacturers can add engineering support for launch, optimization, maintenance, or long-term operations. Delivered systems also include as-built documentation, training, and recommended spares, with service planned around scheduled maintenance windows.

Getting started is a conversation about the process, the production goal, and current constraints, followed by a feasibility review of cycle time, part variation, floor space, and safety. From there GLOBAL recommends whether the fit is a turnkey system, targeted modernization, added engineering services, or a combination, with scope and trade-offs laid out before any commitment. Representative parts and current process data make that assessment faster.